Introduction: detailed installation of Jacuzzi enjoy comfortable bathing
Introduction: detailed installation of Jacuzzi enjoy comfortable bathing
The Jacuzzi is not owned by every family, but with the improvement of the quality of life, its popularity is also increasing. Understand the correct installation steps of bathtub, and reduce the occurrence of various problems such as water leakage of bathtub. The small edition specially brings the detailed explanation of the installation of the massage bathtub for everyone, so willful to understand the skills.
1. Before installing the bathtub, confirm whether the size, form and drainage direction of the bathtub are consistent with the plan. The drainage direction is facing the bathtub. If the bathtub drain is on the left, it is left drainage. If the bathtub drain is on the right, it is right drainage. It's the same idea that the table top of the bathtub is equipped with a faucet.
2. When installing various bathtubs, the surface must be covered with cardboard or wooden board to avoid damage during construction.
3. Do not mix the cement in the bathtub.
4. Do not place the cigarette butts in the bathtub to avoid burning the bathtub surface.
5. After the installation of the bathtub, please remove the residual cement.
6. Do not put sharp or rough appliances in the bathtub during construction, otherwise it will easily cause abrasion of the bathtub surface.
7. To remove the surface dirt, sponge or soft fabric can be used with neutral detergent, do not use acid or alkaline solution, or rough (such as papaya cloth) cleaning tools.
8. If the bathtub is used for a long time or the surface is abraded accidentally during construction, please polish it with car wax to restore the luster of the tableland.
Installation precautions
1. The iron frame combined wallboard must be assembled when it is manufactured in the factory, so the bathtub has already been positioned, only the simple movable wallboard can be added, and the installation method also needs to stick the tiles before installing the wallboard.
2. The movable wall of the living bathtub installed properly can not be removed during maintenance, which is caused by the installation procedure error. Only after the movable wall of the bathtub is installed properly can the tiles be pasted, and the bathtub wall is covered with tile cement, so it can not be removed.
3. If the scope of renovation is not large and it is impossible to bury the power line of independent circuit, an open line must be pulled from the main switch. If the open line is not elegant and the circuit of the original bathroom is unable to carry the current of 15 Amps, a power line that can carry the load must be pulled again from the original pipeline. Please install a leakage circuit breaker at the main switch.