Introduction: bathroom design blind area does not touch the bathroom renovation details

Introduction: bathroom design blind area does not touch the bathroom renovation details


As a leisure place to wash away people's tired body, the design of bathroom shows the owner's inner vision and attitude towards life to a large extent. To quickly understand a person, start with details. So in the face of bathroom design, we need to master the blind area design of bathroom decoration, do not get electric shock, to create a comfortable bathroom, details determine success or failure!


1、 Threshold:


The threshold is a gate to prevent water from overflowing from the bathroom. Its design and construction points are as follows: first, the upper plane of the threshold should incline to the inside of the bathroom so that the water drops can slide smoothly to the inside of the bathroom; second, the threshold should be the same width as the door frame (and the door frame should be the same thickness as the wall), so that there will be no big access when laying the floor tiles, and the chance of creating a breach will be relatively reduced Yes.


2、 Floor waterproofing:


There are many kinds of waterproof materials. At present, waterproof agent is widely used. When laying the waterproof layer, it should be laid to about 20 cm above the wall foot, at least not lower than the height of the threshold. When there is a reserved pipe on the floor, the waterproof layer shall also cover the reserved pipe. After the floor is well waterproof and dry, it must be immediately bottomed with cement mortar or protected to prevent the waterproof layer from being damaged.


3、 Floor tile laying:


There are three main points of floor tile laying: first, there should be about one percent of the water discharge slope, and the slope should face the water outlet under the floor; second, the floor tile joint should be consistent in thickness and aligned with the wall tile joint; third, when the front wall of the bathtub is paved with tile, the floor tile should be first pasted to the bottom of the wall, and then pasted with the wall brick to avoid cracks.


4、 Washstand:


Wash the face of the table to choose "all-in-one" (that is, the surface of the table material and internal material composition, color is the same), can not choose only one layer of surface rubber shell of the table, because only the surface rubber shell of the table can not be repaired once damaged. (to check whether the table top is "all-in-one", the light can be used to irradiate from the back at a close distance, and the transparent one is the "all-in-one" table top). In addition, the joint between the table and the washbasin must be filled with sealant to prevent water from seeping out of the joint.


5、 Toilet:


Generally, when installing the toilet, it is customary to fix the toilet with cement mortar. In fact, this method is wrong. After fixing the toilet with this method, the toilet cannot be disassembled again. If the pipeline is seriously blocked, only one way is to knock the toilet off.


6、 Extraction fan:


Generally, when people build houses, they don't pay much attention to the bathroom ventilation equipment, most of them just install an exhaust fan. The bad gas in the bathroom can't be discharged out of the room. It's still circulating in the bathroom.